Flexy Hybrid Gel Solid Base 4,5 g

Are you dreaming about exceptionally durable stylization and a nail’s free edge that doesn’t chip off? Flexy Hybrid Gel Solid Base is a colorless base coat used under hybrid nail polishes characterized by maximum adhesion to the nail plate. Your manicure will be long-lasting like never before! Carefully selected ingredients provide perfect adhesion, thus the products can be used as a base coat under hybrid nail polishes and for nail extensions. Medium thick consistency enables comfortable work: base coat doesn’t overflow on cuticles ensuring ideal look of nails. It’s recommended to apply it under hybrid nail polish from Flexy Hybrid Gel line – together they form an indestructible duo.

• cured under LED and UV/LED lamp for approx. 30 seconds
• has medium thick consistency, so it doesn’t overflow on cuticles
• enables nail plate extension
• has self-leveling properties that enable creation of C curve and nail refill
• easily soluble in acetone

Hybrid/gel nails

1. Remove the top protective film from the stickers.
2. Cut out the stickers (so that they fit the nail plates).
3. We prepare a vessel with a small amount of water or a wet cotton pad.
4. We prepare the nails for styling, then apply a layer of hybrid or gel and cure in a
5. UV lamp. For a better effect, apply another layer and cure again in the UV lamp.
6. When the nails are ready, dip the appropriately cut sticker in water for 15 - 20 seconds. (or wet it from the bottom by putting it on a wet cotton pad).
7. When the foil separates from the paper, put the sticker on the nail and press it very carefully - smoothing the sticker. If after curing the hybrid or gel sticks too poorly or does not have a dispersion layer at all, we can apply a very thin layer of top coat on the nail and apply a sticker on it without curing (and then cure in a UV lamp).
8. Remove excess sticker with a file.
9. For greater durability, cover the nails on which the stickers are already applied with a top coat and cure in a UV lamp.

Nail polish

1. Remove the top protective film from the stickers.
2. Cut out the stickers (so that they fit the nail plates).
3. We prepare a vessel with a small amount of water or a wet cotton pad.
4. Apply a layer of varnish on the nails and wait about 1 minute. until slightly dry.
5. Then, dip a properly cut sticker in water for 15 - 20 seconds. (or wet it from the bottom by putting it on a wet cotton pad).
6. When the foil separates from the paper, put the sticker on the nail and press gently - smoothing the sticker.
7. Remove excess sticker with a file.
8. For greater durability, we cover the nails on which there are already stickers with a top coat.

PRACTICAL ADVICE: do not push the stickers to the very cuticle and leave a minimum margin at the end of the nail plate.